1 / 7
Jaws for 2 axis woodturning (3cm, 4cm and 5cm diameter) — zdjęcie 1
1 / 7

Jaws for 2 axis woodturning (3cm, 4cm and 5cm diameter)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mounting of workpieces for two-axis turning: Three jaws for use in woodturning chucks like NOVA, RECORD POWER...

Ocena
0 / 5
Polubienia
3
Pobrania
36
Wydruki
0
Wyświetlenia
181
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I try to make little wooden spoons

You first have to turn something akin to a babies rattle and then mount that ball on a different axis. I found Alan Strattons design (https://www.printables.com/model/904340-woodturning-bushing-to-make-scoops) but broke every single one…

What will it do?

With these jaws you can mount balls of 3cm, 4cm and 5cm diameter. They can be clamped strongly in the chuck. You can add additional holding pressure with tightening of the M3 screws. The slits in the sides allow access for depth measuring during hollowing.

In case of a loose fit: just clamp some paper towel with the blank. This is especially smart when you already put a nice finish on.

Versions

This is work in progress:

  • Version 2 features a size tag and broader slits to accomodate smaller objects through clamping.

 Print

I used PCCF, but PLA will probably work as well. 3 perimeters, 30% infill.

 Hardware

  • 2x M3 nuts 

  • 2x 18mm M3 screws

 This is wholly unprofessional! Be advised to act careful around turning thingies.

Tagi