Evil Clown Wall Decor

I present to you the Evil Clown relief sculpture. I made it in three versions out of curiosity just to see if it’s possible.
The smallest one is made of resin, and the largest one, which I’ll probably hang on my door to greet the kids on Halloween ;) is 55 cm tall (printed in four parts on the H2S). It’s very easy to print, with almost no supports (just a bit around the teeth).

If you're interested in the commercial use of my models, earlier access, exclusive designs or if you simply like my work and want to support me, please check out my Patreon at https://patreon.com/29flo and subscribe to a membership tier that suits you.

 

Print Difficulty level: [2/10]

[ Suggested Print Setup for 20 cm figurine ] - You can scale it up or down as desired.

Nozzle: 0.4mm
Layer Height: 0.15-0.25mm ( You can adjust the layer height based on how much detail you want ) 
Infill: 5%
Wall loops: 2
Supports: Tree (auto)
Printed with: 
- PLA Matte Charcoal + Hand Painted
 

These photos are real and show an actual 3D-printed figure photographed by me.
 

As always!
The key to printing my figurines is having good adhesion to the build plate. I use CryoGrip Pro Frostbite for printing, which provides excellent grip, ensuring that every figurine prints successfully every time. I mainly use filaments from Bambu and have no issues with them either. If you have a different setup, make sure to focus on build plate adhesion, use high-quality dry filament, and everything should be fine.