Brompton Pedal Extensions
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extensions for my 2025 Brompton C-line pedals, to support my wide feet. Should fit A-line and other Bromptons.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 31
- Makes
- 0
- Views
- 153
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are pedal extensions for my 2025 Brompton C-line. I find the stock folding and fixed pedals too narrow for my X-Wide feet, so I modelled and printed these extensions. The stock metal pedal parts remain in place on both sides, so there's a not a significant risk if the printed extensions were damaged or failed somehow. The extensions are supported by both the fixing screws on the sides and by several nubs that push into the pedals on the end.
The Fusion 360 models for the pedal frames, the extensions and the reflector holders for the fixed pedal are included, and are largely parametric so that the amount of extension can fairly easily be modified.
The extension for the folding pedal fits using the existing threaded holes for the reflector holders - you will need longer countersunk M4 machine screws to go through the reflector holders. The extension for the fixed pedal uses the holes that secure the metal frame to the plastic pedal part, and in order to move the reflectors to the outside of the extension, you need to print two reflector holders. You then need longer #8-16 thread rolling screws to go through the reflector holders, pedal extension and metal frame into the plastic pedal.
You will need to print:
- 1 x Folding Pedal Extension
- 1 x Fixed Pedal Extension
- 2 x Reflector Holders
And to purchase:
- 2 x Hex drive flat head M4x0.5 12mm long machine screws for the folding pedal. I got these at my local hardware store.
- 2 x Thread rolling screw for plastic, 82° flat head, Phillips drive, #8-16 x 1" Length for the fixed pedal. I used part 0816LPF188 from Amazon.
I printed these in ASA for the heat and UV tolerance with good strength, on my modified Ender 3 Pro (heated enclosure at 50°C, Sprite Pro extruder, Klipper, etc.). The tread grips are designed to be printable directly onto the bed. I found that printing the ASA with significantly higher nozzle temperature than specified (285°C instead of ~250°C), and using Magigoo and a brim avoided warpage. Inserting the support nubs into the ends of the pedal frames and fitting the pedal frames between the sides of the extensions are very tight clearances, and you may need to dial in your printer tolerances. I also used a rubber mallet to get them to install.
I've been riding with these daily for a couple of months, and they are holding up fine. You just have to be careful that you do not scrape them when leaning over to corner, as they are longer than the original pedals. The fixed pedal is just about within the width of the folded bike (see fourth photo).