One Piece Straw Hat Jolly Roger Hueforge
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x145.02mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2mm
#020606 PLA Elegoo Black Transmission Distance: 0.3
#811105 PLA Elegoo Red Transmission Distance: 4
#ffff55 PLA Elegoo Yellow Transmission Distance: 6
#dedede PLA Elegoo White Transmission Distance: 4.3
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Red
At layer #14 (1.2mm) swap to Yellow
At layer #19 (1.6mm) swap to White for the rest.
You can also use my bgcode if You have Core One with 0,4 nozzle: start with any filament in extruder, after calibration and heating it will ask to insert black filament, after this it will pause printing and ask to change filaments in needed moments: black-red-yellow-white.