Joker Noper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A handy little accessory for your Bic lighter.
- Rating
- 5 / 5
- Likes
- 55
- Downloads
- 367
- Makes
- 1
- Views
- 2,665
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is directly inspired by the lovely Toker Poker. I claim no credit for the concept of integrating a tamper and poker into a sleek sleeve for a Bic lighter. The design seemed quite adaptable to 3D printing. I wanted to make something for myself and I wanted to contribute something to the internet community. Please allow me to present to you the “Joker Noper”, a fully 3D printable accessory for your Bic lighter. While the concept is unoriginal, I designed this 3D printable version from scratch.
The “pivot pin” is just a snipped section of filament. The printed holes will likely be a little undersized. I recommend opening them with a round file until you can install the pivot with a little bit of force. Consider it a low-tech friction hinge.
This object is designed to be printed without supports. I think the curves print at good quality at 0.20mm layers. I think it would look a little choppy at 0.30mm. I have not tried at <0.20mm layers but I bet it would look even better!
Dialing in perfect press-fits for a range of printers is quite tricky. On my printer, this part prints as a nice tight slip fit. If you put a little piece of masking tape on one or two of the lower corners of your lighter, I think it'll help keep it retained from the interference.
Happy printing!
-Bloo Wizard