Joker Noper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A handy little accessory for your Bic lighter.
- Ocena
- 5 / 5
- Polubienia
- 55
- Pobrania
- 367
- Wydruki
- 1
- Wyświetlenia
- 2665
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is directly inspired by the lovely Toker Poker. I claim no credit for the concept of integrating a tamper and poker into a sleek sleeve for a Bic lighter. The design seemed quite adaptable to 3D printing. I wanted to make something for myself and I wanted to contribute something to the internet community. Please allow me to present to you the “Joker Noper”, a fully 3D printable accessory for your Bic lighter. While the concept is unoriginal, I designed this 3D printable version from scratch.
The “pivot pin” is just a snipped section of filament. The printed holes will likely be a little undersized. I recommend opening them with a round file until you can install the pivot with a little bit of force. Consider it a low-tech friction hinge.
This object is designed to be printed without supports. I think the curves print at good quality at 0.20mm layers. I think it would look a little choppy at 0.30mm. I have not tried at <0.20mm layers but I bet it would look even better!
Dialing in perfect press-fits for a range of printers is quite tricky. On my printer, this part prints as a nice tight slip fit. If you put a little piece of masking tape on one or two of the lower corners of your lighter, I think it'll help keep it retained from the interference.
Happy printing!
-Bloo Wizard