Minisforum MS-01 Reversible 1U Rack Mount

This is a remix of Gear Seekers' well designed 1U Rack Mount, but with changes made for a three node Minisforum MS-01 Proxmox Ceph Cluster, I mainly wanted the rear I/O of the units to face the front of the rack, to make network configurations and allow slide out the units easier.

I decided to add mounting points for rack ears, so that the MS-01 can be mounted either way. I also integrated the face plate, power button and body into a single piece.

This should also work with Rack Ears to fit in a 10inch Rack. (Not tested yet, but I did the measurements)

Additionally, there is a design to mount three MS-01 power supply units, but it's not well tested.

Parts Required:

• 1U Rack Ears (I just got the most well reviewed on Amazon, but should work for holes which are 23-25mm apart) https://www.amazon.com/dp/B0B6RPMQYR
• M4 Hex Nuts
• 12-16mm M4 Screws (To attach Rack Ears)
• 16-18mm M4 Screws (To attach to Centre Spacer)

Printing Notes:

• Print with front panel on print bed, no additional supports required, there is a built-in support for the hole for the latch.
• I've tested printing in PETG and PLA, but suggest sticking to PETG/ABS for heat resistance.

List of Remix Changes:

• Added Rack Ear mounts for reversible mounting.
• Integrated face plate to main body, also thicken top edge of front panel to add strength.
• Integrated power button with spring mechanism.
• Changed front panel air slots to align with original body.
• Changed Centre Spacer to have same holes as Rack Ear mounts.
• Optional bottom mesh air vent inserts.
• Optional top “lid”.
• 1 x Rack Mount + Rack Ears will fit 10inch Rack.
• Various minor adjustments to thickness and tolerances.
• Optimised design for support-less printing.

Let me know if there's any demand for a version with my changes but also with built in Rack Ears and I'll see what I can do.