Nintendo 64 (N64) USB Raphnet Enclosure For MiSTer FPGA / PC
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Raphnet enclosure for USB-C Arduino Pro Micro board (ATmega32U4) and Nintendo 64 (N64) controller port for MiSTer FPGA.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 17
- Makes
- 0
- Views
- 139
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
The goal was to design a minimalistic enclosure that would allow for inclusion of an arduino pro micro board (ATmega32U4) and OEM Nintendo 64 (N64) controller port. The design is based on a USB-C version of the arduino board. The arduino board has a snug fit - please be sure your arduino board will fit properly. It's possible some arduino boards may use slightly different sizing.
Printing Suggestions:
Material - PLA
Enclosure base - I recommend printing this component with the flat surface on the print bed. Layer height .14mm first layer and .20mm remaining layers. I used 15% infill. I only used supports for the 4 screw hole countersinks. I did not use supports for the USB-C port cutout, however depending on your printer, you may want to enable supports for that as well.
Enclosure top - I recommend printing this component with the flat surface on the print bed. Layer height .14mm first layer and .20mm remaining layers. I used 15% infill. I did not need supports for the angled edges.
Adapter Parts Used:
- (1) Arduino Pro Micro board (ATmega32U4) with USB-C connector (board dimensions: 35mm L x 18.4mm W x 1.65mm H)
- (1) Female Nintendo 64 (N64) controller port
- (1) 5v > 3.3v Voltage Regulator
- (1) 3.3v / 5v Line Level
- (4) 12mm M3 hex screws
- (1) 5mm M1.4 screw
- (4) 5mm M3 brass screw inserts
- 22 or 28 gauge silicon wire
- 1/8" ~ 3/16" shrink tubing