Pot Legs/Potted Plant Stand

If you need some something to bring your potted plants up off the ground to prevent rot on timber decking or excess moisture on concrete, why not use some pot legs?

Simple and easy to print, easy to install, just space 3-5 evenly underneath your pot.

There's 3 sizes, XL for really big pots, regular for most uses and the small one for anything smaller than that.

Print settings are up to you, but I recommend a larger layer size (0.3-0.6) depending on nozzle size, eg, for 0.4mm sized nozzle, use 0.3mm, 0.5mm nozzle size, use 0.4mm, etc. 

Your best bet for longitivity would be ASA. Use 3-4 perimeters and print flat, the perimeter provides the strength so if you have a really heavy pot, use more. Top and bottom layers are up to you, if you want them to look nice, use 4-5, if you just want the bare minium, use 2. For infill, I usually just use gyroid 10-15%, as I mentioned earlier, the strength is really in the perimeter.