Filament Rack fittings for 1/2" PVC
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple filament rack, modular, stackable.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 36
- Makes
- 0
- Views
- 194
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I made a filament rack out of PVC and printed the fittings. These are a fairly tight fit for ½"PVC. I didn't need glue but I'm sure it wouldn't hurt. I tested out if I could glue PVC to PLA with PVC glue and primer, PVC glue no primer, and super glue. All those methods of gluing worked great.
There are 2 main fittings. The base tee90 and the regular tee90. I designed them to be optimized for printing. The other parts are optional. I made plugs for the open ends of the unused tee90's and a plug foot for the front. It adds a bit of stability and a lot of pleasing aesthetics. I made some 90's for the top rack. Those are not at all necessary but I think they look good.
Printed on Prusa Core One
Layer height: 0.16mm, 0.2 would probably be fine too. I just like smaller layer height.
PLA Jayo marble ash concrete
Supports: NO
PVC lengths:
Long side: 400mm about 15 ¾ "
Short side: 75mm about 3"
Vertical sides: 205mm about 8"
Make up whatever works for you.
Feel free to make up anything else with these pieces. Please post interesting makes. Enjoy.