Norns Shield angled case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case for the Norns Shield, angled at 35 Degrees to improve the ergonomics when using the device sat at a desk.
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 579
- Makes
- 4
- Views
- 2,840
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The two files provided are for the printed case and a laser cut screen protector.
The norns Shield is secured in place using 4 M2.5 * 5mm screws, no standoffs are required, only the Shield PCB is screwed in, the Raspberry Pi sits on the printed ledges, it may rattle slightly but ive not found this to be a problem.
The screen protector is friction fit, a very small dab of glue could be used to make sure it doesent move, i didnt find this necaserry.
Make sure to remove the SD card before inserting the RPI, its a snug fit and you may damage the SD card otherwise.