1 / 10
Arrma Mojave 4S Center Shaft Cover — image 1
1 / 10

Arrma Mojave 4S Center Shaft Cover

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Center shaft cover for the Arrma Mojave 4S.

Rating
5 / 5
Likes
10
Downloads
90
Makes
0
Views
377
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

A cover for the center shaft of a Arrma Mojave 4S XXLWB chassis.

I made this because so I don't have to worry about battery wires or anything else getting caught in the shaft.  In addition to covering the center shaft, it also slots over the top of the bearing, providing additional support.

The part is designed for support free printing when oriented top down on the build plate.

Installation requires removal of the center brace. One end is fine as it can swing out of the way.

If you wish to secure with screws, it is designed to use two M3x10 machine screws on the right side of the chassis.   The screw near the middle of the chassis may come through the bottom slightly or bump out some plastic (see picture.)  If you prefer to avoid this, an M3x8 should work, however the center bolt hole doesn't grip until very close to the bottom.
 

Tags