Arrma Mojave 4S Center Shaft Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Center shaft cover for the Arrma Mojave 4S.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 377
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A cover for the center shaft of a Arrma Mojave 4S XXLWB chassis.
I made this because so I don't have to worry about battery wires or anything else getting caught in the shaft. In addition to covering the center shaft, it also slots over the top of the bearing, providing additional support.
The part is designed for support free printing when oriented top down on the build plate.
Installation requires removal of the center brace. One end is fine as it can swing out of the way.
If you wish to secure with screws, it is designed to use two M3x10 machine screws on the right side of the chassis. The screw near the middle of the chassis may come through the bottom slightly or bump out some plastic (see picture.) If you prefer to avoid this, an M3x8 should work, however the center bolt hole doesn't grip until very close to the bottom.