1 / 4
Roku Remote Button Delete (TCL, 4 vertical buttons)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Another variant of a Roku remote button delete. Slightly better fit than similar models for a TCL branded remote.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 26
- Makes
- 1
- Views
- 226
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial
Man I hate these buttons. I get that Roku uses their placement for revenue but doesn't mean we can't over engineer a solution to an inconvenience.
This is a super fast print and under 2g. I used PLA that was loaded in my CC from a previous print but any material will work.
- Remove battery cover and batteries
- Remove the 4 screws (Phillips #000 head)
- I have this set that comes in handy working on small electronics
- Twist/Bend the remote and the plates will separate with a little force and allow dissemble
- Be careful as the ok/arrow button is 2 pieces and the separate membrane, these will likely fall out as you are taking ti a part for the first time
- Cut away the branded buttons, I just uses scissors but a knife or razor blade would also work
- Reassemble by placing membrane button, ok/arrow button (make sure to oriented OK properly), snap together
- reinstall screws, batteries, and battery cover