Eibos Cyclops Foot Repair
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.86 – €1.05 net (excluding VAT)
For file: Eibos Foot Repair V1_0.2mm_PETG_MK3S_1h2m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.95 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 1.03 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A simple print to repair fragile broken feet on an Eibos Cyclops filament drier.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 37
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The feet on my Eibos Cyclopes Filament Drier are extremely fragile and when I bumped into my drier the foot broke clean off along with breaking the bottom panel! I created a model that slips over the broken screw peg and gives it some more vertical support along with some more horizontal support for the foot to actually rest on.
Features:
- Thicker walls for more vertical support allowing the leg to absorb more horizontal pressure.
- Snug fit around the existing foot support post.
- Large horizontal foot platform for both foot and back panel support.
Important Notes:
- You will most likely need larger/longer screws to resecure the leg back in place. I used 1 ¼" drywall screws which worked perfectly into the existing fragile plastic. The factory screws were not only not long enough after my legs broke but they were stripped!
Installation Instructions:
- Open the back panel by unscrewing any remaining feet.
- Press the repair piece over the existing foot screw column.
- Highly recommend installing this repair for all other feet even if they are fine because why not
- Reinstall the back panel.
- Reinstall the foot with a larger/longer screw
- Again I used a 1 ¼" drywall screw and it worked great!
My Print Config:
Prusa MK3S+ 40mm Nozzle, PETG, 0.20mm layer height. No supports, nothing fancy.