1 / 5
Voron V0 camera mount for Innomaker U20CAM USB camera — image 1
1 / 5

Voron V0 camera mount for Innomaker U20CAM USB camera

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mounting parts for "Innomaker U20CAM" USB webcam for Voron V0.2 printer

Rating
0 / 5
Likes
3
Downloads
38
Makes
0
Views
285
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

Mounting accessories to mount a “Innomaker U20CAM” camera (found on Amazon, does 1080p30, has manual close focus distance, very wide angle, and works well with Linux/Crowsnest) in a Voron V0.2 top lid.

On the Umbilical Mod board, there is a convenient notch to route the cable!

You need:

  • The camera, comes with detached USB cable.
  • 2x M2.5x4 screws
  • 1x M3 4-6mm screw. No nuts :)

Assembly

  • Print the parts in ABS/ASA like every Voron part.
  • Mount the camera module to the main body with two M2.5 screws, don't overtighten!
  • Route the cable through the notch (temporarily remove one screw to pull the board and cover plate aside for this)
  • Connect the camera and slide the body into the extrusion slits
  • Attach the plate against the main body and mount the M3 screw. No nuts needed (though you could slide some in from below)
  • Fix the cable with the upper cable clip, leave some slack for opening and cl
  • Fix the cable with the lower cable clip. push it as far back as possible, then pull towards the front just about 1mm so the lid still can close
  • Arange the cable, make sure your toolhead can move freely!

Tags