1 / 5
Voron V0 camera mount for Innomaker U20CAM USB camera
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting parts for "Innomaker U20CAM" USB webcam for Voron V0.2 printer
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (10)Powiązane
Mounting accessories to mount a “Innomaker U20CAM” camera (found on Amazon, does 1080p30, has manual close focus distance, very wide angle, and works well with Linux/Crowsnest) in a Voron V0.2 top lid.
On the Umbilical Mod board, there is a convenient notch to route the cable!
You need:
- The camera, comes with detached USB cable.
- 2x M2.5x4 screws
- 1x M3 4-6mm screw. No nuts :)
Assembly
- Print the parts in ABS/ASA like every Voron part.
- Mount the camera module to the main body with two M2.5 screws, don't overtighten!
- Route the cable through the notch (temporarily remove one screw to pull the board and cover plate aside for this)
- Connect the camera and slide the body into the extrusion slits
- Attach the plate against the main body and mount the M3 screw. No nuts needed (though you could slide some in from below)
- Fix the cable with the upper cable clip, leave some slack for opening and cl
- Fix the cable with the lower cable clip. push it as far back as possible, then pull towards the front just about 1mm so the lid still can close
- Arange the cable, make sure your toolhead can move freely!