[TPU ONLY] Port Gap Fillers + Better Bumper Spacers for CNC PubBox V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Never lose those damn bumper spacers again! Make your board look nicer!
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Fill the voids where the charge port and power button meet the openings in the rails, and replaces the terrible default bumper shims! Designed for the V2 CNC PubBox for VESC XR/Funwheel by Huff Designs, which can be found at https://makerworld.com/en/models/963939-cnc-pubbox-for-vesc-xr-funwheel
Normally when you install this box into the rails there's a gaping void around the charge port where dirt and crap can get in between your rails and box. If you're using a charge port connector with an external threaded lock ring like a GX16, it also tends to get stuck on the threads and it's too far in to unscrew easily (assuming you haven't just cut the lock ring off already). These parts fill the empty space for a cleaner look and block off the threads! For those who sweat the details, there's another one for the power button too.
They also replace the small bumper shims that are normally required for use with XR-style bumpers like TFL B.A.N.G Bumpers; the PubBox was designed to be compatible with stock Future Motion XR bumpers which have a little finger that fits between the rails and box, so you need the shims for any bumpers that don't have the finger. The standard ones aren't held in place by anything without the bumper on, so they're easy to lose and a pain to install. Since people who use these boxes typically never use FM bumpers anyways, they've been integrated into the fill pieces for convenience.
RECOMMENDED SETTINGS:
Orient as shown in the third picture, use supports on the buildplate only, and up the wall count to 6-8 so the integrated bumper spacers are stiff enough. High infill isn't necessary; the part should have some give to it to be able to fit properly and solid infill is a waste of material. Because the spacer fingers are so thin, a high wall count will make them solid while leaving the rest of the part intact.
These are designed to be printed in TPU! Non-flexible materials will not work.
Credit to Treez of the Vescify Discord for providing the cover photos so I didn't have to take apart my own board!
