4x Charger for Undercabinet LED Lighting
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For those that use a lot of these, charging can be a pain. I designed this so I can charge 4 simultaneously and easily.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 39
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
I use these undercabinet lights: https://m.media-amazon.com/images/I/612T9O91YtL._AC_SL1500_.jpg
I'm sure this would work with any of the many, many clones of this light as they are all the same as far as I can tell.
Each charge via USBA to USBC cable. Charging each one individually is a pain, so I designed a charger that uses the original cables along with a 4x USB charger to charge 4 at a time. Take the USBA to USBC cables that they come with, slide it through the cutouts on the side, and it should interference fit into a slot at the base of the area that the lights get slid into. Route the cables through the bottom channel, out one side and I found a printable wire loom to help manage them. I bought a cheap 4x USBA charger for 7 bucks off of amazon and its good to go. I did add some rubber stick on pads to give it a bit more stability.
I just used PLA, 10% infill and 3 walls. Not sure it matters all that much.