The Presence organizer insert

The Large versions are simply larger: more plastic, but a tighter fit; the normal version have the same size as the game component (e.g., "Token Visitors" has the same size as visitors boards).

"Pawns" is a shorter version of "Pawns High" and "Pawns High Full": "Pawns" is shorter, to be used together with "Pawns Support" (so the pawns don't fall out if the box is vertical or upside down); "Pawns High" is a higher version, which leaves empty space on top; "Pawns High Full" is as high as "Pawns High", but has the bottom filled to remove the empty space on top (same effect of "Pawns" + "Pawns Support", more plastic).

"Pawn Support X" is just as "Pawn Support", but less plastic and quicker to print; I added it after a suggestion by JasonLowe.

"Stopper" is simply to stop the campaign book and the boards from moving around.

Each "Token Secret Board" slot houses five tokens, so you can put the clue tokens of each spirit in one and have them ready for any game.

All the content ends being a couple of millimiters lower than the lid, I solved this by putting the original blister under the organizer; if you don't have it, just a piece of cardboard 2 mm high solves the issue.

The prints in the photos are:

Doors
Pawns + Pawns Support
Token Secret Board
Token Visitors
Stopper

Supports: no.
Layer: 0.2 mm.
Infill: 8% gyroid; if you want a stronger print up it to 10-20% infill.