Cage Corner Bracket Reinforced
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The brackets from atomotec were a little too big for my cage, and when I scaled them down to 85% so they fit one of…
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 79
- Makes
- 1
- Views
- 478
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial
The brackets from atomotec were a little too big for my cage, and when I scaled them down to 85% so they fit one of them broke because it wasn't strong enough.
I loaded the bracket into Tinkercad and added 2 mm to the top and sides and replaced the one that broke.
About a week later one other corner bracket has broken and been replaced. The other four seem ok so far.
I also wanted a bracket for the straight sections so I clipped off the end of the corner bracket in Tinkercad and made it longer for a straight bracket. It ended up being too short to hold well so I am printing more at 150% length.
The straight bracket is uploaded with the original and reinforced dimensions.
Update: The straight brackets tend to split when printed flat on the back, I would try printing them vertically as they are in the stl.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
50%
Notes:
I printed them with 6 walls, 4 top and bottom layers.
Category: Pets