Cage Corner Bracket Reinforced
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The brackets from atomotec were a little too big for my cage, and when I scaled them down to 85% so they fit one of…
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 79
- Wydruki
- 1
- Wyświetlenia
- 478
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
The brackets from atomotec were a little too big for my cage, and when I scaled them down to 85% so they fit one of them broke because it wasn't strong enough.
I loaded the bracket into Tinkercad and added 2 mm to the top and sides and replaced the one that broke.
About a week later one other corner bracket has broken and been replaced. The other four seem ok so far.
I also wanted a bracket for the straight sections so I clipped off the end of the corner bracket in Tinkercad and made it longer for a straight bracket. It ended up being too short to hold well so I am printing more at 150% length.
The straight bracket is uploaded with the original and reinforced dimensions.
Update: The straight brackets tend to split when printed flat on the back, I would try printing them vertically as they are in the stl.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
50%
Notes:
I printed them with 6 walls, 4 top and bottom layers.
Category: Pets