Breakout Board Case ESP32
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.30 – €0.37 net (excluding VAT)
For file: Breakout Board Case ESP32_0.4n_0.2mm_PLA_MINIIS_15m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.34 excluding VAT (range midpoint).
- Weight reported by the author
- 6 g
- Print time reported by the author
- 15 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Simple Case for an ESP32 Breakout/Expansion Board
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 56
- Makes
- 0
- Views
- 393
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a simple case for an ESP32 Expansion/Breakout Board. Not so much a case as a guard for the bottom of the board so you don't worry about the contacts on the bottom touching things. It is designed for the ESP32S 38P/V4/Goouuu Expansion Board.
The breakout board is cheaply constructed, it does not appear as though holes are very consistent between boards. The f3d file is included so you can adjust hole locations as needed.
I used two M2x4 screws with washers to secure the board.