1 / 5
Makita battery to Rockwell 18v (old Ni-Cd) tool — image 1
1 / 5

Makita battery to Rockwell 18v (old Ni-Cd) tool

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Makita battery to Rockwell 18v (old Ni-Cd) tool

Rating
0 / 5
Likes
2
Downloads
24
Makes
0
Views
171
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

Makita battery to Rockwell 18v (old Ni-cd) tool

Extra requirements

2 x 9.5mm male spade terminals
2 x 6mm long male spade connectors

5x M3 nuts
5 x M3 10mm socket head bolts
2 x wires

35mm long, 5mm diameter, 0.5 gauge spring, clicky pen spring might work too

Assembly Guide

I find if I run a 3mm drill bit through all the bolt holes, it helps with getting the bolts in smoothly.

Install wires onto 9.5 male terminals, clip off the small wings on each side and flatten out the delta shape between the crimp and the spade (see photo), this will help it fit into the slots of the adaptor. Install the male terminals into the bottom section and feed the wires through the hole, install the cover plate with a nut and bolt.

Place the top roughly into position so you can estimate where to trim the wires. Once trimmed, install the prepared 6.3mm long terminals, I give them a squeeze so they will fit nicely in the final position. 

Put the side buttons and spring into position and use the remaining 4 nut and bolts to secure the top to bottom.

Install the 6.3mm long terminals into position, noting the correct polarity.

I can adapt to other slide in style batteries, just let me know and I can probably make it.

If you like this model, please throw me a like.  Designing the models is time, filament and coffee consuming. If you want to support my work buy me a coffee (PayPal). Thanks!
 

Tags