Welch Allyn Otoscope pneumatic otoscopy insufflator tip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement tip for Welch Allyn pneumatic otoscopy tube. Best to print with the press fit top up. I print at 0.1…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 26
- Makes
- 0
- Views
- 387
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Medical Tools
- License
- Creative Commons — Attribution
Replacement tip for Welch Allyn pneumatic otoscopy tube.
Best to print with the press fit top up. I print at 0.1 layers with supports. Usually print in ABS, be careful with heat. I usually keep the cooling fan at 50% and print multiple or keep layer time >10s.
Print Settings
Printer:
Anycubic I3 Mega
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
100
Notes:
I print them upright with a brim and support. It was pretty difficult to get it to lay down the first layer correctly, so the larger the brim the better most likely. I used 0.1mm layer height and print at around 40mm/sec print speed. Takes about 14 minutes to print. Works well and is sturdy. If you require more airflow you can take a 1/16 drill bit to ream the middle prior to use, but it works fine either way.
Category: Parts