Držiak Stretch folie - Stretch wrap holder
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€6.09 – €7.44 net (excluding VAT)
For file: Drziak folie_0.4n_0.25mm_2PER_15FILL_PETG_XLIS_4h31m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €6.77 excluding VAT (range midpoint).
- Weight reported by the author
- 141 g
- Print time reported by the author
- 4.52 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Jednoduchý držiak stretch folie do jednej ruky - Simple one-handed stretch wrap holder
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 19
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Jednoduchy držiak malej stretch baliacej folie do jednej ruky. Pri balení si môžeš brzdiť odvijanie palcom ruky aby bola folia pevne napnutá. Pri vkladaní rolky stlač spolu k sebe rozdelený koniec držiaka a nasaď rolku. Tak isto aj pri vyberaní rolky najprv spolu k sebe stlač koniec a pretlač rolku von. Pripravil som aj 3mf subor v ktorom su zadefinované miesta so 100% výplňou. Tlačil som z PETG kvôli lepšej pružnosti. Nie je nutné tlačiť z ASA alebo PC. Kedže sa jedná o držiak s celkovou výškou 310 mm tak som na hornej delenej časti použil drobné podpery, ktoré su sučastou modelu. Pozri obrázok. Po vytlačení ich jednoducho odstrániš ostrím nožíkom. Pozor na prsty ! Použitie organických podpier by veľmi predlžilo čas tlače aj spotrebu materialu. Tlačil som na Prusa XL ale zvládne to aj Prusa Core One L.
Ak sa ti model páči klikni na srdiečko a keď ho vytlačíš ohodnoť hviezdičkami a prilož fotku. Ďakujem.
A simple holder for a small stretch wrapping film in one hand. When wrapping, you can slow down the unwinding with your thumb so that the film is tightly stretched. When inserting the roll, press the divided end of the holder together and insert the roll. Similarly, when removing the roll, press the end together first and push the roll out. I also prepared a 3mf file in which the places with 100% filling are defined. I printed from PETG for better flexibility. It is not necessary to print from ASA or PC. Since this is a holder with a total height of 310 mm, I used small supports on the upper divided part, which are part of the model. See the picture. After printing, you can simply remove them with a sharp knife. Watch out for your fingers! Using organic supports would greatly extend the printing time and material consumption. I printed on a Prusa XL but the Prusa Core One L will also do it.
If you like the model, click the heart and when you print it, rate it with stars and attach a photo. Thanks.