Mellow Fly ADXL345 Accelerometer mount for Lemontron (rev e)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple mount for a Mellow Fly ADXL345 for the Lemontron Rev E toolhead
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 16
- Makes
- 0
- Views
- 157
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This mount CANNOT be used during normal printing - you must put it on before use and remove it once finished.
Remove the screws attaching the toolhead to the X carriage and screw the mount in place, so that it screws the toolhead back in (you'll need longer M3 screws than the stock wafer heads that were already there). Then screw the ADXL module in with M3 8mm countersunk screws. Make sure it is tight, so your readings are accurate!
adxl.cfg:
[mcu adxl]
serial: /dev/serial/by-id/usb-Klipper_rp2040_E6626005A7815734-if00[adxl345]
cs_pin: adxl:gpio9
spi_software_sclk_pin: adxl:gpio10
spi_software_mosi_pin: adxl:gpio11
spi_software_miso_pin: adxl:gpio12
[resonance_tester]
accel_chip:adxl345
probe_points: 80,80,20