Flashforge AD5X LED Stadium Lighting
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Light bars to go above the printing area on Flashforge AD5X
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 134
- Makes
- 0
- Views
- 1,007
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
I came up with a way to flood the printing area with light, just like a stadium. This also keeps the light behind the camera so the image isn't all washed out. I grabbed a couple of LED lights off of amazon for less than $20 each and made a holder for them.
www.amazon.com/FLASHFORGE-AD5M-LED-Strip-Replacement
For the bar that mounts above the door, drill a small 1/16th inch hole to pilot the screws. Screw in a couple of 3mm screws and washers into the boss that mounts into the frame.
The bar that mounts on the right side, I installed several 5mm magnets and super glued them into place. A couple of them needed some attention with a soldering iron to get them to sit all the way down. I wasn't happy with how the magnets were holding things in place so a couple pea sized dollops of hot glue sealed the deal.