Flashforge AD5X LED Stadium Lighting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Light bars to go above the printing area on Flashforge AD5X
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 134
- Wydruki
- 0
- Wyświetlenia
- 1007
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I came up with a way to flood the printing area with light, just like a stadium. This also keeps the light behind the camera so the image isn't all washed out. I grabbed a couple of LED lights off of amazon for less than $20 each and made a holder for them.
www.amazon.com/FLASHFORGE-AD5M-LED-Strip-Replacement
For the bar that mounts above the door, drill a small 1/16th inch hole to pilot the screws. Screw in a couple of 3mm screws and washers into the boss that mounts into the frame.
The bar that mounts on the right side, I installed several 5mm magnets and super glued them into place. A couple of them needed some attention with a soldering iron to get them to sit all the way down. I wasn't happy with how the magnets were holding things in place so a couple pea sized dollops of hot glue sealed the deal.