Combiner Wars leg replacement/ fill in
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Leg for the Transformers Combiner wars toys.(Combiners, not individual figures)
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 0
- Views
- 133
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution
This leg is compatible with normal combiner wars combiner slots, and can be connected to the hand/foot guns.
________________________________________________________________________________________________________________________________
To assemble, take the two rectangular pegs and slide them into the designated slots on one half of the leg. Proceed to the snap ball joint/knee into the designated slot. Finally snap the other half of the leg onto the other to create a combiner's leg.
Finally(optional): There is a tiny stick to slide into the sides of the ball joint and outside of the ball socket (AFTER ASSEMBLY AND MIGHT NEED SANDING BEFORE SLIDING IN).
This stick was added to provide extra stability.
________________________________________________________________________________________________________________________________
There are three pieces of the assembly that require you to remove supports. (SUPPORTS ARE PROVIDED IN THE MODEL). If you would prefer, slicer supports might add extra stability.
On the two halves of the truck, there are two bricks that support the slot of the knee.
On the knee joint(ball joint), there are two small pieces of support underneath the ball joint.
________________________________________________________________________________________________________________________________
Slap this thing on your combiner's missing leg and you are good to go!