VCore 3.1 Machined AWD and Lever M3 Tensioner
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
CNC brackets, motor mounts, and printed parts based off of BRS Engineering's Lever M3. V2 out now
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 19
- Makes
- 0
- Views
- 237
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
V2 is here
Hard mount the motors
machined tensioner arms
Better bearing retention
much better IS results
Easier to machine (except for the tensioner arms)
General
This design is based off of BRS Engineering's Lever M3. It's what I was using up until I got a CNC machine and wanted to try to convert the Lever M3 into something machined. This version also makes servicing and monitoring the belts, couplers, and toothed idlers much easier.
This is for the v-core 3.1 and only compatible with Enclosure 2.0
The entire assembly is included below if you want to fix or improve this design.
Parts
Basic Part Summary
Aluminum Top AWD plate
Aluminum Bottom AWD plate
3D printed tensioner and retainer bits
3D printed main Motor Mount (attaches to vertical extrusion)
Aluminum plate that goes between the motor and the above printed motor mount
Plate Decision
There are 2 versions of the plate designs: simplified and “full featured”. Both need an M3 tapped for the F625 retainer and both are relatively simple.
Simplified
Can 95% be water or laser cut
Couldn't get around a small pocket on the right bottom plate
Only need to machine 1 side per plate
Simple to machine, took me about 40 mins per plate on a Carvera Air
Full Featured
Still relatively simple
Only need to machine 1 side per plate
Nice-to-haves that the “simplified” version does not
captive M4 nuts
Better hold, and easier maintenance over threaded holes - if you strip a nut, just replace it instead of the whole plate
Pocket runner for the top tensioner washers
Keeps things from wobbling in theory
I am using the simplified version just fine.
What to Print and Buy
Look below at the included files, the descriptions tell you if they should be CNC'd or 3D printed, and how many are required.
Hardware BOM
Tools
M3 tap
Misc Hardware
4mm ID, 6-8mm OD, 30mm long shafts x 12
Various M3, M4, and M5 bolts and nuts (check the assembly model)
Longest bolts you need
M3x20mm
M4x40mm
M5x50mm
Heat set inserts
M5 heat set inserts x4
M3 heat set inserts x2
Couplers
stepper motor couplers x2
A way to create
17mm bearing spacer x2
15mm bearing spacer x2
3mm bearing spacer x2
1mm shim x10 (or however many you need to equal the above)
Bearings
F625-2RS x4
Shoulder Bolts
M4 5mm SD x 40mm Bolt x2
M4 5mm SD x 35mm Bolt x4
If you're confused, look at the assembly CAD or message me
Happy printing!
If you want to find out how to watercool your printer, check this guide out
Like what I do and want to support me? Buy me a coffee!