Tsurikawa Strap Clamp - No Screws Needed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This model was designed to replace those pesky Tsurikawa clamps that all use screws and nuts.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I was tasked with designing some tsurikawas and quickly became super annoyed with having to source screws and nuts for the strap clamps. From that frustration was born this design of a screw-less strap clamp that just clips together. Once together, you can simply give the strap a slight twist to pop it apart for removal.
Print them in the orientation seen in the photo.
No supports needed.
0.2mm layer height
100% infill
The clamp is designed for 1" (1 inch) wide webbing. The included template can be used for punching the holes in the strap. The etched squiggly line denotes the side to use at the edges of the strap. So one side will get all 4 holes and then the other side just the 2 holes at the edge.