IKEA Styrbar Adapter for Feller EdizioDue (No Rewiring / Schema 3)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Feller EdizioDue adapter for IKEA Styrbar. Keeps power ON for smart lights. No rewiring.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 4
- Makes
- 0
- Views
- 88
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
The Problem: If you use smart lighting (IKEA Trådfri, Philips Hue, etc.), the physical wall switch needs to stay powered 100% of the time. However, standard Swiss switches (Feller EdizioDue) are often accidentally turned off by family members or guests, killing the connection to your smart bulbs.
The Solution: This 3D printed spacer adapter allows you to replace the standard Feller rocker (Wippe) with the IKEA Styrbar remote control.
Keeps Power ON: By screwing the IKEA metal bracket through this adapter, it mechanically locks the underlying switch in the "ON" position.
No Rewiring: You do not need to access the cables or use Wago connectors. It is a purely mechanical add-on.
Clean Finish: The adapter fills the gap between the Feller frame and the IKEA bracket, ensuring the remote sits flush and does not wobble.
Compatibility
Remote: IKEA Styrbar (Square version).
Wall Switch: Feller EdizioDue.
Tested on Schema 3 (Standard single-pole/two-way switch).
Should also fit Schema 1, Schema 6, and Schema 0 (Push-button/Taster) as they share the same frame geometry.
Not compatible with double-rocker switches (two small buttons side-by-side).
Hardware Required
1x M3 x 20mm Screw
Note: The standard screw included with the switch or the IKEA remote is usually too short or has the wrong thread. You need a 20mm M3 screw to reach the thread in the Feller mechanism through the added depth of the adapter.
Installation Instructions
Remove Rocker: Pull the plastic rocker button (Wippe) off your existing Feller switch.
Insert Adapter: Place the 3D printed spacer ring into the switch opening.
Position Bracket: Place the IKEA Styrbar metal mounting plate over the adapter.
Secure: Screw the M3x20mm screw through the center hole of the IKEA bracket and into the Feller mechanism.
Tightening this screw presses the mechanism into the "ON" position and locks it there.
Finish: Snap the IKEA Styrbar remote magnetically onto the bracket.
Print Settings
Material: PLA or PETG (White matches the Feller frame best).
Infill: 15-20% (Rectilinear or Grid).
Supports: None required.
Layer Height: 0.2mm recommended.