1 / 2
IKEA Styrbar Adapter for Feller EdizioDue (No Rewiring / Schema 3) — zdjęcie 1
1 / 2

IKEA Styrbar Adapter for Feller EdizioDue (No Rewiring / Schema 3)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Feller EdizioDue adapter for IKEA Styrbar. Keeps power ON for smart lights. No rewiring.

Ocena
0 / 5
Polubienia
3
Pobrania
4
Wydruki
0
Wyświetlenia
92
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

The Problem: If you use smart lighting (IKEA Trådfri, Philips Hue, etc.), the physical wall switch needs to stay powered 100% of the time. However, standard Swiss switches (Feller EdizioDue) are often accidentally turned off by family members or guests, killing the connection to your smart bulbs.

The Solution: This 3D printed spacer adapter allows you to replace the standard Feller rocker (Wippe) with the IKEA Styrbar remote control.

  • Keeps Power ON: By screwing the IKEA metal bracket through this adapter, it mechanically locks the underlying switch in the "ON" position.

  • No Rewiring: You do not need to access the cables or use Wago connectors. It is a purely mechanical add-on.

  • Clean Finish: The adapter fills the gap between the Feller frame and the IKEA bracket, ensuring the remote sits flush and does not wobble.

Compatibility

  • Remote: IKEA Styrbar (Square version).

  • Wall Switch: Feller EdizioDue.

    • Tested on Schema 3 (Standard single-pole/two-way switch).

    • Should also fit Schema 1, Schema 6, and Schema 0 (Push-button/Taster) as they share the same frame geometry.

    • Not compatible with double-rocker switches (two small buttons side-by-side).

Hardware Required

  • 1x M3 x 20mm Screw

    • Note: The standard screw included with the switch or the IKEA remote is usually too short or has the wrong thread. You need a 20mm M3 screw to reach the thread in the Feller mechanism through the added depth of the adapter.

Installation Instructions

  1. Remove Rocker: Pull the plastic rocker button (Wippe) off your existing Feller switch.

  2. Insert Adapter: Place the 3D printed spacer ring into the switch opening.

  3. Position Bracket: Place the IKEA Styrbar metal mounting plate over the adapter.

  4. Secure: Screw the M3x20mm screw through the center hole of the IKEA bracket and into the Feller mechanism.

    • Tightening this screw presses the mechanism into the "ON" position and locks it there.

  5. Finish: Snap the IKEA Styrbar remote magnetically onto the bracket.

Print Settings

  • Material: PLA or PETG (White matches the Feller frame best).

  • Infill: 15-20% (Rectilinear or Grid).

  • Supports: None required.

  • Layer Height: 0.2mm recommended.

Tagi