1 / 11
Hot glue Sleeve, shell mold for JST-XH connector — image 1
1 / 11

Hot glue Sleeve, shell mold for JST-XH connector

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mold for make cable shell for JST-XH or similar connectors (for battery pack).

Rating
5 / 5
Likes
63
Downloads
366
Makes
2
Views
4,369
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Mold for make cable shell for JST-XH or similar connectors. It work with PETG and glue not to hot, about 170-180°C

Please note! I made these parts in the context of battery balancing cards. The S indicates the number of cells. And there's always one more wire than the number of cells. So a balancing plug for a 3S battery should contain 4 pins. So, if you need a 4-pin plug, you'll need to print the '3S' file.

The file 'moule-fiche-jst-xh-splited.stl' contains the separate elements needed to rebuild the mould for the number of pins you want.

https://www.youtube.com/watch?v=vetH\_S9nsAE&t=10s

1 - Put anti-attachement in the mold.
2 - Put the JST connector in the right piece.
3 - Put a few glue in the midle pieces.
4 - Place the right pieces and the center pieces together
5 - Fill the center pieces near full
6 - Put quick and tight the left pieces
7 - Wait 5 minutes for the cooling down
8 - Turn out and remove moulding protrusions

Print instructions

Unassociated tags: cable protection, protection de câbles
Category: R/C Vehicles

Tags