Daggerheart Resource Tracker for sliders - Card-sized with Insert
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
REMIX. This card-sized Daggerheart accessory tracks Hope, Armor Slots, Hit Points, and Stress.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 17
- Makes
- 0
- Views
- 258
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Miniature Gaming Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix, of a cardsized resource tracker made by @Grison_15297. This compact resource tracker is the same size as a standard Daggerheart card, but thicker. It uses sliders to track Hope, Armor Slots, Hit Points, and Stress. Optional blanks can be slotted in to indicate the character's current maximum in a given section.
Everything prints without supports. I used a 0.2mm layer height.
If you use the blanks, you'll need to print multiples.
The maximum you could theoretically need is 3 sets of blanks per tracker, but realistically you'll need far fewer. They are intentionally tight so they don't fall out so easily. You can shave a bit off or print them a tiny bit smaller if they are too tight with your printer. Same goes for the sliders.
If you use the largest blank to block off a whole row (numbers 7-12), you can remove it later by flexing the tracker until one end of the blank pops up. It's pretty forgiving.