Daggerheart Resource Tracker for sliders - Card-sized with Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
REMIX. This card-sized Daggerheart accessory tracks Hope, Armor Slots, Hit Points, and Stress.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 255
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix, of a cardsized resource tracker made by @Grison_15297. This compact resource tracker is the same size as a standard Daggerheart card, but thicker. It uses sliders to track Hope, Armor Slots, Hit Points, and Stress. Optional blanks can be slotted in to indicate the character's current maximum in a given section.
Everything prints without supports. I used a 0.2mm layer height.
If you use the blanks, you'll need to print multiples.
The maximum you could theoretically need is 3 sets of blanks per tracker, but realistically you'll need far fewer. They are intentionally tight so they don't fall out so easily. You can shave a bit off or print them a tiny bit smaller if they are too tight with your printer. Same goes for the sliders.
If you use the largest blank to block off a whole row (numbers 7-12), you can remove it later by flexing the tracker until one end of the blank pops up. It's pretty forgiving.