ASUS ROG Strix GeForce RTX 2080 Ti Custom Fan Shroud
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This project contains a custom fan shroud for ASUS ROG Strix GeForce RTX 2080 Ti.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 88
- Makes
- 1
- Views
- 822
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
One of the fans on my graphics card gave out, so I set out to design a custom shroud that can hold 120 mm Noctua Chromax Black fans, and it should work just as well with 120 mm Be Quiet fans.
The shroud mounts directly onto the cooler with screws, and the fans are secured from the sides with their own screws.
I also installed threaded inserts in every mounting point, using a soldering iron to heat and seat them with some fine adjustments along the way (angle and position). THIS STEP IS NOT MANDATORY!
Used material:
11x M2 x 6mm screws (example: https://www.amazon.de/WZHUIDA-Innensechskant-Unterlegscheiben-Gewindemaschinen-Sechskantschrauben/dp/B0DJ948G7K/ref=sr_1_10?sr=8-10)
(optional) 11x M2 threaded inserts (https://www.3djake.at/ruthex/m2-m3-m4-m5-gewindeeinsatz-sortimentskasten?sai=15214&gad_campaignid=21639248292)
4-pin PWM extender (Example: https://www.amazon.de/Noctua-NA-SEC1-4-Pin-Verl%C3%A4ngerungskabel-Schwarz/dp/B00KG3K9AM)
A few notes:
It really comes down to your motherboard (or if you are using a risercard) and the slot where your graphics card sits. In my setup, the 4-pin PWM extensions wouldn’t fit underneath the shroud, so I routed them alongside the fans instead and let them exit at the corner.
I used the external fan connectors of the graphics card. Therefore, I made a very easy and userfriendly peace of software to control just the external fan header. It's working on Windows10+ and also Linux.
Here is my repo: https://github.com/Tunefish92/FanConnect-II-ControllerYou can also use a Y-cable to connect them together and use a fan controller directly on the mainboard
Printer:
- Prusa Core One
- eSun PETG / 3DJake ASA
- 0.4mm nozzle
- 0.15mm STRUCTUAL profile
- 20% fill
- Orca Slicer
UPDATE (25.9.2026): Added a link to my repo for easy and efficient fan control
UPDATE to V3 (3.1.2026):
- Adjustment of mounting holes on the cooler
- Reduced wall thickness on the bottom from 5mm to 4mm (If you are using threaded inserts, push them more in, to have a clean surface when the screw is on final position.
If you have any feedback, suggestions or anything, please leave a comment :)