OMP M2 V3 Pro canopy guide
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.17 – €0.21 net (excluding VAT)
For file: Canopy Guide_0.4n_0.15mm_PLA_COREONE_13m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.19 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 12.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Protects the canopy during crashes with your Omphobby M2 V3 Pro helicopter
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 28
- Makes
- 0
- Views
- 118
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I found out the hard way that the canopy of my M2 V3 Pro easily gets damaged during a crash, just because one of the screws on front corner of the frame sticks out like a hole punch. When the helicopter crashes on its side, the canopy gets pressed onto this screw wich results in an ugly "wound" in the lovely paint.
You can of course reinforce the canopy from the inside with some epoxy, but I decide to address the root cause by designing this small guide piece that fits over the screws and is held in place under the connector bracket. It sits really nice, flush to the canopy and does give it a more sturdy feel. The weight is negligible.
Printed in PLA, 0.15 layers, 0% infill, no supports. To assemble, undo the 4 screws of the frame and the connector brac