GMT800 LT Silverado / Tahoe / Suburban / Yukon ATOTO USB (1999-2007)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These prints make installing the USB ports into the dash of a GMT800 easy if it has the cubby.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 41
- Makes
- 0
- Views
- 1,311
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These prints are to install the Atoto USB ports into the dash of a GMT800.
They use the original cubby if so equipped. The dash face plate easily pops off (see youtube) and you can remove the cubby by removing the M8 headed screws.
The "drill guide" needs to have m3 heat inserts installed as well in the main USB mounts. The drill guide fits snuggly into the cubby just the same as the usb mount will but allows a heated finish nail (held by pliers) to be pushed thru the insert so you can transfer the hole center to the outside of the cubby and enlarge them with a drill bit. Print the USB mount face down, I did glass for a smooth surface but a textured plate may be desired.
The bottom of the cubby is drilled with a 1" forstner bit. The two strain relief are assembled with the nut side on the inside of the cubby with the cables loosely installed inside. Pull the cables thru until the usb mount is in the right place and bolt it with the 4 bolts thru the side. Then don't pull hard tight or even push a slight amount of slack back into the cubby and tighten the strain relief center bolt to lock into place.
Hole to the left side is for a pen/pencil.
STEP file of it is included for any personal modifications your heart may desire