1 / 9
Bosch/Siemens Refrigerator (KGE39EI41/94) Door Shelf (Part No.: 11013214 & 00745358) Push Lid Fix — image 1
1 / 9

Bosch/Siemens Refrigerator (KGE39EI41/94) Door Shelf (Part No.: 11013214 & 00745358) Push Lid Fix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a fix for the broken parts of the lid of a Bosch/Siemens refrigerator E-No KGE39EI41/94 doorshelf.

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
69
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
GNU General Public License v3.0

English:

This is a fix for the defective part of the lid of a door shelf in a Bosch/Siemens refrigerator with the E-number KGE39EI41/94. The current Bosch part number for the door shelf is 11013214 (old part number: 00745358).

The door shelf and cover are made of crystal-clear PP, which is not very flexible, which is why it broke twice on both sides for me. After pushing it, the cover could no longer be opened and did not stay open, which should normally be the case.

The part can be printed in PETG (recommended) or PLA without support and is pressed around the part of the lid (left and/or right) that engages with the storage compartment where the push mechanism is located (holds without glue). The part looks a bit like a semicircle. Here it replaces the straight, broken part of the lid. The rounded part was still fine. In the pictures you can see the broken part (splintered plastic).

German:

Dies ist ein Fix für den defekten Teil des Deckels einer Türablage eines Bosch/Siemens-Kühlschranks mit der E-Nr. KGE39EI41/94. Die aktuelle Bosch-Teilenummer für die Türablage lautet 11013214 (alte Teilenummer: 00745358).

Die Türablage und der Deckel bestehen aus kristallklarem PP, das nicht sehr flexibel ist, weshalb es bei mir zweimal auf beiden Seiten gebrochen ist. Der Deckel ließ sich nach einem Push nicht mehr öffnen und blieb auch nicht mehr oben was normalerweise aber der Fall sein sollte.

Das Teil kann in PETG (empfohlen) oder PLA ohne Support gedruckt werden und wird jeweils (links und/oder rechts) um den Teil des Deckels herum gedrückt (hält ohne Kleber), der in den Ablageteil greift, wo sich der Push-Mechanismus befindet. Der Teil sieht ein wenig wie ein Halbkreis aus. Hier ersetzt es den geraden, abgebrochen Teil des Deckels. Der abgerundete Teil war noch in Ordnung. Auf den Bildern sieht man den abgebrochen Teil (gesplittertes Kunststoff).

Tags