x56 HOTAS faceplate for Elite: Dangerous
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Faceplate for the Logitech x56 HOTAS. it has labels for Elite: Dangerous based on my control setup.
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 257
- Makes
- 0
- Views
- 3,656
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
UPDATE: i made a new version of this as a remix. Its not quite the same and requires you to have transparent PLA, but looks much better and requires no tape to be visible.
Faceplate for the Logitech x56 HOTAS. it has labels for Elite: Dangerous based on my control setup.
It requires you to take the throttle apart, not terribly difficult but make sure you have a small enough hex key to get the screws on the front off.
works well aside from a fairly low viewing angle, but putting some scotch tape over the lettering helps alot. a thinner print may also help. Its also a bit too small on the left side, so 2 of the screws won't fit back in place. fits snug without them, though.
included is a .dwg if you'd like to make any changes/fix my mistakes
NOTE: You may need to peel off the sticky bit that holds the diffuser onto the clear plastic. I don't have pictures, but when you get it apart youll know what i mean. Its just so the led shines through fully and isnt blocked by the adhesive on the top and bottom.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
dosnt mater
Notes:
should be solid regardless of infill
Category: Other