1 / 11
M12x1.5 Blind Stuffing + Nut and TPU-Sealing / M12x1.5 Blindstopfen + Mutter und TPU-Dichtung — image 1
1 / 11

M12x1.5 Blind Stuffing + Nut and TPU-Sealing / M12x1.5 Blindstopfen + Mutter und TPU-Dichtung

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

M12 blind stuffing to close unused openings for PG7 cable gland in housings (ca 12.0mm). Optional TPU-sealing available.

Rating
5 / 5
Likes
12
Downloads
145
Makes
3
Views
321
Reviews
3

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

M12x1.5 threaded blind stuffing to close unused M12-openings or PG7-openings in housings.

[1] Thread type:
  Metric tread

[2] Diameters for suitable openings:
  Diameters for M12x1.5 opening:
  a) threaded hole:                    10.5mm / M12x1.5 thread
  b) drill hole without thread:  12.5mm / no thread
  Diameters for PG7 opening:
  a) threaded hole:                    11.3mm / PG thread -> Not fitting without widening to 12.0 mm diameter.
      In this setting you can use 
      https://www.printables.com/model/1467336-pg7-blind-stuffing-nut-and-tpu-sealing-pg7-blindst
      as alternative.                                               
  b) drill hole without thread:  12.5mm / no thread

[3] Sealing:
  An optional TPU-sealing model file is available.

Print
Material:   PETG (blind stuffing, nut), TPU 95A (sealing)
Supports: not required
Brim:         not required
Serial printing (part by part) for better thread quality.

Assembly
Threaded opening:
Screw the blind stuffing into the M12x1.5 opening.
Optionally place sealing on stuffing before assembly.
Unthreaded opening:
Place blind stuffing in PG7/M12 opening and secure with M12x1.5 nut.
Optionally place sealing on stuffing before assembly.
Use a 1€ coin for turning of the blind stuffing.

Hint: 
Apply some silicone grease on the thread, so it can be easily be assembled and disassembled.
(Without grease, the thread tends to wind on and off somewhat “sticky”.)

Tags