1 / 11
M12x1.5 Blind Stuffing + Nut and TPU-Sealing / M12x1.5 Blindstopfen + Mutter und TPU-Dichtung — zdjęcie 1
1 / 11

M12x1.5 Blind Stuffing + Nut and TPU-Sealing / M12x1.5 Blindstopfen + Mutter und TPU-Dichtung

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

M12 blind stuffing to close unused openings for PG7 cable gland in housings (ca 12.0mm). Optional TPU-sealing available.

Ocena
5 / 5
Polubienia
12
Pobrania
145
Wydruki
3
Wyświetlenia
321
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

M12x1.5 threaded blind stuffing to close unused M12-openings or PG7-openings in housings.

[1] Thread type:
  Metric tread

[2] Diameters for suitable openings:
  Diameters for M12x1.5 opening:
  a) threaded hole:                    10.5mm / M12x1.5 thread
  b) drill hole without thread:  12.5mm / no thread
  Diameters for PG7 opening:
  a) threaded hole:                    11.3mm / PG thread -> Not fitting without widening to 12.0 mm diameter.
      In this setting you can use 
      https://www.printables.com/model/1467336-pg7-blind-stuffing-nut-and-tpu-sealing-pg7-blindst
      as alternative.                                               
  b) drill hole without thread:  12.5mm / no thread

[3] Sealing:
  An optional TPU-sealing model file is available.

Print
Material:   PETG (blind stuffing, nut), TPU 95A (sealing)
Supports: not required
Brim:         not required
Serial printing (part by part) for better thread quality.

Assembly
Threaded opening:
Screw the blind stuffing into the M12x1.5 opening.
Optionally place sealing on stuffing before assembly.
Unthreaded opening:
Place blind stuffing in PG7/M12 opening and secure with M12x1.5 nut.
Optionally place sealing on stuffing before assembly.
Use a 1€ coin for turning of the blind stuffing.

Hint: 
Apply some silicone grease on the thread, so it can be easily be assembled and disassembled.
(Without grease, the thread tends to wind on and off somewhat “sticky”.)

Tagi