Befiederungsgerät für 3 Vanes / Fletching Jig for 3 vanes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Befiederungsgerät zum Befiedern von Schäften von 4,5mm bis 8mm / Fletching Jig for shafts from 4,5mm OD up to 8mm OD
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 214
- Makes
- 1
- Views
- 818
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Noncommercial
Für Schäfte von 4,5 bis 8mm Außendurchmesser
Man benötigt die base, eine cap mit dem Außendurchmesser des Schafts (nächste Größe) und drei Inserts mit dem gewünschten Winkel (0°, 1°, 1,5° oder 2°)
Der Bajonettverschluss funktioniert am besten, wenn der Zapfen und die Führung mit etwas Support gedruckt wird, siehe Abbildung
For shafts with an outer diameter of 4.5 to 8 mm
You will need the base, a cap with the outer diameter of the shaft (next size), and three inserts with the desired angle (0°, 1°, 1.5°, or 2°).
The bayonet fitting works best if the pin and guide are printed with some support as shown in the image.

Die senkrechte Vertiefung an der Basis zeigt die Position der Führungsfeder (90° zur Sehne).
Die Einsätze mit Winkel (1°, 1,5° und 2°) sind im STL jeweils für Links und Rechts enthalten. Im Slicer das STL in Objekte trennen, senkrecht stellen und die gewünschte Variante 3x ohne Support drucken.
The vertical indentation at the base indicates the position of the guide vane(90° to the string).
The inserts with angles (1°, 1.5°, and 2°) are included in the STL file for both left and right sides. In your slicer, split the STL file into objects, orient them vertically, and print the desired variant three times without supports.

Falls die Vanes nicht mit Sekundenkleber, sondern mit länger abbindenden Kleber befestigt werden, können die 3 Einsätze mit einem Gummiband fixiert werden.
27.12.25 Update zu den Einsätzen: Bei der Version 1.1 ist der Aufnahmespalt schmaler, sodass die Vanes strammer sitzen. Damit das nicht zu eng wird, ist dafür der vordere Teil verdünnt, um eine Flexibilität zu erzeugen, dies funktioniert sowohl mit PLA als auch mit PETG.
If the vanes are attached with a longer-setting adhesive instead of superglue, the three inserts can be secured with a rubber band.
December 27, 2025 Update on the inserts: In version 1.1, the mounting gap is narrower, resulting in a tighter fit for the vanes. To prevent this from becoming too tight, the front section has been thinned to allow for flexibility. This works with both PLA and PETG.
Gedruckt mit
PLA
0.2mm
2 Perimeter
15% Infill
Infill Adaptiv Kubisch
Kommentare, Makes, Verbesserungsvorschläge und Änderungswünsche sind willkommen.
Printed with:
PLA 0.2mm
2 Perimeters
15% Infill
Adaptive Cubic Infill
Comments, builds, suggestions for improvement, and change requests are welcome.