Adapter from Chemical Guys spray bottle to 1/8" NPT (NPT2) female thread
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount a 1/8" NPT fitting on a Chemical Guys spray bottle, primarily to clean the nozzles of the Dualco grease gun.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 39
- Makes
- 0
- Views
- 513
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Allows mounting a 1/8" NPT (aka "NPT2") fitting directly to the threads of a Chemical Guys spray bottle.
I use the Chemical Guys spray bottle for several things at home because they're durable, work well, and are inexpensive to replace when certain cleaning products (bleach solution) finally breaks down the plastic. All other cleaners we use - 99% alcohol, Windex, Simple Green aerospace solution - the bottles work great and last forever. While I was cleaning out a Dualco grease gun with the intention of changing grease, I wanted to clean out the long nozzle as well as I could. I used a Q-tip to clean the threaded end, and then used air to get most of the grease out of the long nozzle, but then thought it would be nice to be able to pump alcohol through it, and thus the idea for this was born. I remove the stock spray nozzle, thread this into place, thread the nozzle onto it, and a couple pumps of the trigger cleans out the remainder quite nicely.
A note on the thread - it measured at either 0.9mm pitch or 28tpi - which is effectively the same. The threads measure out at 11.7mm but there wasn't an M12x0.9 option in the thread library. Looked at the SAE options and there was 7/16-28 and 1/2-28. The first was far too small, and the second was a bit too big. So ultimately I wound up modeling the thread myself and it came out to about a 12.15 x 0.9mm thread. Guessing it's some proprietary thing, but this at least worked and came out well.
This might fit other spray bottles, but I haven't tested on anything else.
If you use this for the same purpose, just be warned that there is a bit of internal volume between the sprayer and the 1/8" NPT fitting, so when you pull it all apart, you'll get a bit of spillage.
Print instructions
I did prototypes in 0.2mm layer heights (0.4mm nozzle) with only 2 shells and it seemed strong enough. No supports needed. I wouldn't go with a coarser layer height than 0.2mm as I've found for printed threads having a layer height that is 1/4 the pitch (or smaller) gives the best results.
Material is up to you. If it's too tight because of your printer or filament choice (don't blame the design) you might need to scale up a couple percent in the X and Y planes, but leave Z alone or you'll throw off the thread pitch.