Prusa Core One / One+ Convection Mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
for this kit you will need 2 50mm fans + GPIO "Hackerboard"
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 46
- Makes
- 0
- Views
- 1,001
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Open Community License v1
This is my vesion of convection mod for the Prusa Core One / Core One+
Hardware needs:
2 50mm 24Volts fans
1 GPIO "Hackerboard" set.
8 M3x16 screw
1 MOSFET driver 0-24V 3,3V ( it is use to control 24V via GPIO output)
In my case I have found a Mosfet dual driver module from an old Arduino project.
I have use this extra hardware, but you can use every alternative you like:
Gcode mod
On start G-code inter this aftet:
{if chamber_minimal_temperature[initial_tool]!=0}
; Min chamber temp section
M104 S{idle_temperature[initial_tool]} ; set idle temp
G1 Z10 F720 ; set bed position
G1 X242 Y-9 F4800 ; set print head position
M262 P7 B0 ; set pin 7 as output
M264 P7 B1 ; set pin 7 to hight/on
on end G-code add
M262 P7 B0 ; set pin 7 as output
M264 P7 B0 ; set pin 7 to low/off
Asap I will update the installation manual.
If you use the fans without a cover under the heatbed you may cool heatbed more than you heat it, here you can find a mold for a silicone cover.