1 / 9
180 degree Pivoting J1772 wall mounted charger  holder — image 1
1 / 9

180 degree Pivoting J1772 wall mounted charger holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Swinging Holder for your J1772 charger swings 180 degrees. Secures to a single stud.

Rating
0 / 5
Likes
4
Downloads
22
Makes
0
Views
224
Reviews
0

Updated at source:

Model information

Category
Vehicles
License
Creative Commons — Attribution — Share Alike

Swinging J1772 bracket that allows you to lay the charger flat against the wall and swing it out as needed. Printed in PET 40 % but may go higher depending on longevity. Prints in place as one object. A little crunchy in the joint as the pivot suports release. If scaling is an issue the total height is 7.5 inches tall. Narrow base allows attachement to a single wall stud. Remix, comments welcome. 

Tags