1 / 9
180 degree Pivoting J1772 wall mounted charger  holder — zdjęcie 1
1 / 9

180 degree Pivoting J1772 wall mounted charger holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Swinging Holder for your J1772 charger swings 180 degrees. Secures to a single stud.

Ocena
0 / 5
Polubienia
4
Pobrania
22
Wydruki
0
Wyświetlenia
224
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Share Alike

Swinging J1772 bracket that allows you to lay the charger flat against the wall and swing it out as needed. Printed in PET 40 % but may go higher depending on longevity. Prints in place as one object. A little crunchy in the joint as the pivot suports release. If scaling is an issue the total height is 7.5 inches tall. Narrow base allows attachement to a single wall stud. Remix, comments welcome. 

Tagi