Protective Latching Box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small case to keep your belongings safe
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 77
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
FDM printed in PETG for strength, this little box can store all your small belongings while also latching closed with a satisfying click.
It uses minimal supports, and also is pretty easy to print. It can be made waterproof if sealed with a rubber gasket and finished with plastic safe clearcoat.
It worked fine printing with a layer height of 0.2mm, any lower and it was going to take a couple too many hours in my opinion.
It was originally designed to fit an Arduino uno minima along with a 400 pin breadboard, but has many other uses as well.
You will need some wire for the front latches and two nails for the hinges (Or similar objects)
Always make sure to add glue to your build plate before printing with PETG to avoid damaging it.
DISCLAIMER: This worked great on my Centauri Carbon, but individual results may vary. You have been warned.